C+114MD Portable Pump Assembly

$2,325.00

The following assemblies ship within 24 office hours:

  • 1 / 115 Volt Single Phase / D

The C+114MD is the original C-series centrifugal pump re-imagined. It has kept the original casing design and popular external mechanical seal options, however it features a collar that clamps down on the drive shaft over a full 360 degrees removing the minor wobble that can occur from set screwed shafts. The impeller pin was also replaced with a threaded impeller nut that fully secures the impeller in place; there are two specialized gaskets to seal the shaft and to still allow a CIP procedure to clean behind the impeller. The collar and bolted impeller reduce rattling sounds at lower speeds.

The C+114 pump head is attached to our stainless steel washdown motor, mounted on a Canadian made stainless steel cart and fitted with a NEMA 4X variable speed control (VFD).

Features:

  • 1 1/2" X 1 1/2" Tri-clamp connections
  • Stainless steel washdown motor
  • 316L stainless steel construction (wetted parts)
  • 304 stainless steel adapter
  • External mechanical seal
  • Canadian made stainless steel cart
  • NEMA 4X VFD

SEAL OPTIONS:

"D" Single mechanical external seal

"DG" Single mechanical external seal with replaceable ceramic seat

"F" Single mechanical external seal with water cascade 

Horsepower

1 HP:The capacity of this pump is 75 GPM and it will put out 65 ft of head pressure, ideal for microbreweries (5 - 10 BBL) and estate wineries.

1 1/2 HP:The capacity of this pump is 100 GPM and it will put out 75 ft of head pressure, ideal for microbreweries (10 - 15 BBL) and estate wineries.

2 HP:The capacity of this pump is 125 GPM and it will put out 75 ft of head pressure, ideal for microbreweries (> 15 BBL) and larger estate wineries.

3 HP The capacity of this pump is 150 GPM and it will put out 75 ft of head pressure, ideal for large microbreweries (>25 BBL) and larger estate wineries.

You might also like

Sale

Unavailable

Sold Out